TEST PRODUCT ON A SMALL AREA TO CHECK ACID SENSITIVITY BEFORE FULL APPLICATION.
If satisfied with test results, remove all loose dust and dirt from the surface.
Apply when surface temperature is 5 to 35 °C (40 – 95 °F).
Pre-wet very porous surfaces with water to prevent cleaner penetrating too deeply.
TED is highly concentrated and must be diluted with clean water. Recommended dilutions: a. Efflorescence, rust marks – 1 part TED to 10 parts water. b. Grout haze, limescale, soap scum – 1 part TED to 20 parts water
Pour, brush or spray mixed solution generously onto surface and leave for 3 minutes.
Do not allow solution to dry on surface. Clean large areas in sections.
Rub with a white nylon scrub pad, or similar, to clean the surface.
TED is highly acidic and must be neutralized before rinsing: Use Oxitec-M or dissolve 1 cup of bicarbonate of soda in a bucket of water. Pour, spray over the entire surface and leave for minimum 3 minutes.
Rinse surface thoroughly several times with clean water.
NOTE: TED is highly acidic and will etch acid sensitive materials such as marble, limestone, travertine and onyx. Concrete should be wet before applying TED and neutralized immediately afterwards to minimize damage.
Precautions
Do not handle until all safety precautions have been read and understood.
IF ON SKIN: Wash with plenty of soap and water. • IF INHALED: Remove to fresh air and keep at rest in a position comfortable for breathing. • IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do.Continue rinsing. • Call a POISON CENTER or doctor/physician if you feel unwell.
Specific treatment is advised – see first aid instructions. • If skin or eye irritation occurs: Get medical advice/ attention. • Take off contaminated clothing and wash before re-use.
